So I was bored Sunday and figured I had been putting off doing this long enough. I run a printer out of my truck every day for work so I use a power inverter but my nice one died and I had to buy a smaller one to get me by until I got this new one in...

First, the inverter:


very close up pic of soldered wires to the back of the switch on the control board (not very good at soldering):


Mounted inverter in a tool box in the bed:


Plug in and switch mounted (almost looks like it should be there from the factory):


Dash back together:



Yep, it works!:


Here's the bed:


I was really excited with how it came out and it was way easier than trying to build a place to mount the big faceplate or put holes in my speaker box. I plugged an extension cord into the inverter and then cut the other end and spliced the wires into the back of the plug in that I stole from the old inverter that I have been using for the last 4 years that finally died.

Let me know what you guys think!